Pelco DX8100-ISCI ユーザーズマニュアル

World Headquarters 
3500 Pelco Way, Clovis, California 93612 USA 
USA & Canada  Tel: 800/289-9100   Fax: 800/289-9150
International  Tel: 1-559/292-1981  Fax: 1-559/348-1120
www.pelco.com

Pelco and the Pelco logo are registered trademarks of Pelco, Inc.

Information subject to change without notice.

©Copyright 2008, Pelco, Inc. All rights reserved.

Page 1 of 21                                DX8100-ISCI_SCSI_CARD_SATABoy.fm

April 16, 2008

Before you install the DX8100-ISCI SCSI card, familiarize yourself with the instructions in this Tech 
Tip. The steps to install the external video storage upgrade are summarized as follows: 

1. Unpack the DX8100-ISCI kit and check that you have all the necessary kit components. 

2. Verify that you have the required tools to install the SCSI card. For information about the tools 

required to install the SCSI card, refer to Tools Needed table above.

3. Shut down the DX8100 Series DVR. For information about shutting down the DX8100, refer to the 

DX8100 Installation Manual, Operation and Programming manual, or DX8100 Server online Help.

4.  Unplug the power cord from the wall socket. 

WARNING: It is critical that the unit be unplugged for your safety. You must remove the power 

cord because current continues to flow through the DX8100 even when the unit is off. Remove 
the power cord from the wall socket first, and then from the rear of the DVR. 

1

Phillips screwdriver #1 (nonmagnetic)

1

Properly grounded electrostatic discharge (ESD) wrist 
strap and mat

4

Small containers for storing screws (optional)