Siemens M7-400 ユーザーズマニュアル

4-48

S7-400, M7-400 Programmable Controllers Module Specifications

A5E00069467-07

You can only set the input delay for each group of channels. In other words, the
setting for channel 0 applies to inputs 0 to 7 and the setting for channel 8 applies to
inputs 8 to 15.

The parameters that are entered for the remaining channels (1 to 7 and 9 to 15)
must be equal to the value 0 or 8, otherwise those channels will be reported as
being incorrectly parameterized.

Any hardware interrupts that have occurred in the meantime will be reported after
acknowledgement.

You can achieve the fastest signal propagation delay with the following settings:

•

Both channel groups are parameterized with an input delay of 0.5 ms

•

The Diagnostics parameter is disabled

•

The Diagnostic Interrupt parameter is disabled