Fujitsu B23Q8YA-G-02-E ユーザーズマニュアル

restore the slice unit.

If you back up slice 0, it will only be possible to restore to a disk having the same physical

properties (such as disk space and a number of cylinders) as the original.

Disk partition information such as the size of each slice will not be backed up. You must record

the information separately.

To back up the disk unit, use the dd(1M) command after booting from the Solaris OS CD/DVD.

If you are restoring, use the dd(1M) command after booting from the Solaris OS CD/DVD to

restore the disk unit.

The procedure divides the disk unit for back up, so it is only possible to restore to a disk having

the same physical properties (such as disk space and a number of cylinders) as the original.

It is recommended that you select the SCSI device with target ID 1 for Solaris OS installation. Before

selecting the disk to install Solaris OS, make sure it is connected to the SCSI adapter plugged into the PCI

slot of PCI0B. In this case, the device name of the system disk will be "c0t1d0" (obtained from the

controller number (0), target ID (1), and LUN number (0)). If you install Solaris OS to other than the disk

having the device name "c0t1d0", (especially, a disk having the controller number other than 0) take care to

carefully obtain the correct device name.

If applying the optional software that runs as part of the driver and file system from the system disk,

carefully follow the instructions and notes described in the manual of each option. For example, if you

configure disk mirroring using PRIMECLUSTER GDS, you must select the backup procedures described in

a. above, because the PRIMECLUSTER GDS driver does not exist in the CD/DVD files. In addition, if the

system disk contains a file system other than the ufs file system such as PRIMECLUSTER GFS, select the

backup procedures using the backup command provided in the file system or the dd(1M) command.