Fujitsu D1241 ユーザーズマニュアル
32
User’s Manual
3. HARDWARE SETUP
Connectors
3. H/W SETUP
CUR-DLS
R
CUR-DLS SCSI Connection Example
68-pin Internal SCSI Cable (Twisted-Pair Ribbon)
68-pin Female
Terminator
Terminator
Internal SCSI Devices (up to 15 devices)
Channel A
68-pin Internal SCSI Cable (Twisted-Pair Ribbon)
68-pin Female
Terminator
Terminator
Internal SCSI Devices (up to 15 devices)
Channel B
SCSI Connection Notes
This motherboard has two 68-Pin Ultra160/Ultra2 (depending on model) SCSI con-
nectors; one for each of the two channels.
nectors; one for each of the two channels.
The onboard SCSI chipset incorporates an advanced multimode I/O cell that sup-
ports both single-ended (SE), Ultra2, and Ultra160 devices. With Ultra160/Ultra2
devices, the SCSI bus platform performs at full Ultra160/Ultra2 speeds (up to 160MB/
sec or 80MB/sec) and extended cabling 12m (or 25m in a point-to-point configura-
tion). When an SE device is attached, the bus defaults to an SE speed and 1.5m cable
length.
ports both single-ended (SE), Ultra2, and Ultra160 devices. With Ultra160/Ultra2
devices, the SCSI bus platform performs at full Ultra160/Ultra2 speeds (up to 160MB/
sec or 80MB/sec) and extended cabling 12m (or 25m in a point-to-point configura-
tion). When an SE device is attached, the bus defaults to an SE speed and 1.5m cable
length.
IMPORTANT: Connect SCSI devices as shown. Each channel should have only
one type of SCSI standard (e.g. Ultra160, Ultra2, Ultra-Wide). Mixing SCSI devices
on the same channel will decrease performance to the slower device.
one type of SCSI standard (e.g. Ultra160, Ultra2, Ultra-Wide). Mixing SCSI devices
on the same channel will decrease performance to the slower device.
NOTE: Ultra160/Ultra2 devices do not have termination jumpers and must use a
separate terminator on the last connector (internal) or device (external).
separate terminator on the last connector (internal) or device (external).