Fujitsu C122-E177-01EN ユーザーズマニュアル
MMB CLI (Command Line Interface) Operations
2.2.8 sadump
Specify sadump to specified partition.
When the partition which is specified by the parameter is not configured, the partition is ignored.
When the specified partition is not in Power On state, any kind of processing for such partition is not done.
Partition Operator can operate only the partition to be managed.
When the parameter which contains the partitions other than those to be managed is specified, an error
message is displayed and the specified partition cannot be operated.
When the partition which is specified by the parameter is not configured, the partition is ignored.
When the specified partition is not in Power On state, any kind of processing for such partition is not done.
Partition Operator can operate only the partition to be managed.
When the parameter which contains the partitions other than those to be managed is specified, an error
message is displayed and the specified partition cannot be operated.
Privilege: Administrator, Operator, Partition Operator (Only the partition to be
managed)
(1) Input format
sadump {partition} [<partition#> [, | -] <partition#>] {quiet}
(2) Option
partition: This option specifies a sadump of the partition identified by the specified partition number. This
partition can be omitted.
partition#: Partition number. Even if the partition parameter is omitted, processing assumes that the partition
parameter is specified. Therefore, a partition number must be specified.
Partition is number specified as follows.
Partition is number specified as follows.
Partition numbers are separated by comma
Specifies with the range of partition number
quiet: The command is executed without interactive operation with the user.
(3) Usage example
Example: When sadump is specified to Partition#1 by Administrator Authority
Administrator> sadump partition 1
Are you sure you want to sadump to Partition#1? [Y/N]: Y
Administrator>
Are you sure you want to sadump to Partition#1? [Y/N]: Y
Administrator>
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
Are you sure you want to sadump to Partition#%d? [Y/N]:
The specified parameter is invalid.
The specified partition number is invalid.
Unable to sadump the partition#%d.
Command Failed. Code=0x%04X, 0x%02X
Unable to execute this command on a standby MMB.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Unable to sadump the Partition#n because you have not authority to operate this partition.
Unable to sadump the partition(s) because the partition which does not have authority to you is included in
the specified parameter.
The specified parameter is invalid.
The specified partition number is invalid.
Unable to sadump the partition#%d.
Command Failed. Code=0x%04X, 0x%02X
Unable to execute this command on a standby MMB.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Unable to sadump the Partition#n because you have not authority to operate this partition.
Unable to sadump the partition(s) because the partition which does not have authority to you is included in
the specified parameter.
2.2.9 reset
Specify the Hard Reset to the specified partition.