Epson S1C62 Family ユーザーズマニュアル
ICE CONTROL SOFTWARE ICS62XX
S1C62 FAMILY
EPSON
VIII-9
DEVELOPMENT TOOL REFERENCE MANUAL
2.2.2
Starting the ICS62XX
■
Start the Operating System
First, call up the operating system (abbreviated OS below) for your general purpose personal computer.
The ICS62XX can operate in the following OS environments.
The ICS62XX can operate in the following OS environments.
PC-DOS version 2.10 or higher
Refer to your OS manual for procedures on loading the system. After loading the system, set the HOST
setting as described in Section 2.2.1, "HOST settings".
setting as described in Section 2.2.1, "HOST settings".
■
Starting the ICS62XX
(1) Insert the ICS62XX system software (supplied with CD-ROM) to the assigned drive in your personal
computer.
(2) Input the following information through the keyboard.
B>ICS62XX
...The Epson logo is displayed for about one second...
* ICE POWER ON RESET *
* DIAGNOSTIC TEST OK *
# _
* DIAGNOSTIC TEST OK *
# _
Cursor position
When the ICS62XX system program is loaded in the computer as described above, control of the
computer is given to the ICS62XX system program. ICS62XX commands are awaited when the program
is properly loaded and the # mark is displayed.
computer is given to the ICS62XX system program. ICS62XX commands are awaited when the program
is properly loaded and the # mark is displayed.
■
Quitting ICS62XX Control
The ICS62XX program is terminated by entering the Q command; control is then returned to the
computer's operating system.
computer's operating system.
#Q
B>
B>