HP (Hewlett-Packard) VS19 ユーザーズマニュアル

Special messages display on the monitor screen for the following 
monitor conditions:
■ Input Signal Out of Range — Indicates the monitor does 

not support the video input signal because the resolution or 
refresh rate are set higher than the monitor supports. 

 

Set the resolution and refresh rate to the value displayed. 
Restart your computer for the new settings to take effect.

■ Monitor Going to Sleep — Indicates the screen display 

is entering a sleep mode. The speakers are turned off in 
sleep mode.

■ Check Video Cable — Indicates a video input cable is not 

properly connected to the computer or monitor.

■ OSD Lock — The OSD can be enabled or disabled by 

pressing and holding the Menu button on the front panel for 
10 seconds. If the OSD is locked, the warning message 
“OSD Lock” displays for 10 seconds.
❏ If the OSD is locked, press and hold the Menu button for 

10 seconds to unlock the OSD.

❏ If the OSD is unlocked, press and hold the Menu button 

for 10 seconds to lock the OSD.

■ No Input Signal — Indicates the monitor is not receiving a 

video signal from the computer on the monitor video input 
connector(s). Check to see if the computer or input signal 
source is off or in the power-saving mode.

■ Auto-Adjustment is in Progress — Indicates the 

Auto-adjustment function is active. See “Adjusting Screen 
Quality” in this chapter.