Acu-Rite CNC 3500i ユーザーズマニュアル
180
7 Programming: Canned Cycles, sub-programs
7.
2 Canned Cy
cles
Frame Pocket Cycle
Use the frame pocket cycle to mill a frame or trough around an
island of material. You must position the tool directly over the center
of the island, or use the X Y words.
island of material. You must position the tool directly over the center
of the island, or use the X Y words.
Activate the tool prior to programming, so the cutter diameter is
known.
known.
Field
Code
Description
Length
M
Length of island in X-axis. (Required)
Width
W
Width of island in Y-axis. (Required)
StartHgt
H
Z absolute starting height (0.1” or 2 mm
above surface). Executed in rapid.
(Required)
above surface). Executed in rapid.
(Required)
ZDepth
Z
Absolute depth of frame pocket. (Required)
Frame
Width
Width
C
Width of removed trough or frame.
(Required)
(Required)
StepOver
A
The distance the tool steps over (width of
cut) in the X and Y axes as it mills out the
pocket. Defaults to tool radius, which is the
max.
cut) in the X and Y axes as it mills out the
pocket. Defaults to tool radius, which is the
max.
XCenter
X
X coordinate of the island center point.
Defaults to current position.
Defaults to current position.
YCenter
Y
Y coordinate of the island center point.
Defaults to current position.
Defaults to current position.
InsideRad
U
The arc radius of all four inner corners of the
island. Defaults to tool radius, which is the
minimum value allowed.
island. Defaults to tool radius, which is the
minimum value allowed.
Outside
Rad
Rad
V
The arc radius of all four outer corners of
the frame pocket. Defaults to U (InsideRad)
value. Must exceed tool radius.
the frame pocket. Defaults to U (InsideRad)
value. Must exceed tool radius.
DepthCut
B
The depth of each cut per pass. Defaults to
tool diameter. Max is the full ZDepth in
parameter Z, less bottom finish stock. A
negative value will cause the finish pass to
finish the side walls in steps down.
tool diameter. Max is the full ZDepth in
parameter Z, less bottom finish stock. A
negative value will cause the finish pass to
finish the side walls in steps down.