Brady 76800 ユーザーズマニュアル

Working with Labels

Check this option to set a custom label width. Enter 
the new width in the entry field. The value entered 
must be less than the maximum printable width 
appropriate for the installed tape, because unlike the 
default width, this value indicates the total output 
width, with no margins applied. This means that the 
printable area will equal the amount you specify 
here. (See Checking Sizen page 11-11 for more 
discussion on this topic.)

 

With the Monocolor and the Multicolor systems, the 
label prints with dashed lines that indicate the 
label’s dimensions. 
With the Color & Cut system, the label is cut around 
its outside dimensions.
Note: Objects previously placed on the label keep 
their original size when you resize a label using this 
feature. You must manually resize any objects that 
no longer fit within the new label size. For 
information on resizing objects, see Sizing 
Objectsn page 7-27.
This option is not available when Match tape 
width is enabled. When Match tape width is 
enabled, the value in this field shows the current 
width of the label for display only.

Check this option to accept the length the system 
automatically sets, based on the contents of the 
label. If you have a paneled ribbon installed, the 
maximum label length is set to the panel length. 

When this option is enabled, your label 

automatically prints with the objects centered on the 
length dimension of the label. The system achieves 
this by calculating the space between the leading 
edge of the label and the first object on the label, 
then adding that same amount of space after the last 
object on the label. 

When this option is selected, the Set length option 
is unavailable (grayed out).