Brady 76800 ユーザーズマニュアル
B-4
Adjusting the Cut Depth
Adjusting the Cut Depth
You may need to adjust the stylus blade on your cutter when:
z
The cuts on your cut out labels are either too deep or too shallow.
z
You install tape supplies of varying thickness.
The stylus holder has an adjustment dial you use to change the depth at which the
stylus blade cuts the tape.
stylus blade cuts the tape.
Step 1:
Turn the power off, and open the printer. Follow the instructions in the Removing
the Stylus Holder section above to remove the stylus holder, shown here:
the Stylus Holder section above to remove the stylus holder, shown here:
Figure B-2. The stylus holder.
The stylus blade protrudes very slightly from the stylus nose. The stylus glides
across the tape when cutting your label.
across the tape when cutting your label.