DYMO SE450 ユーザーズマニュアル
3
Installing as a Serial ASCII Printer (Windows)
1
Plug the end of the serial cable with the RJ11 connector
into the serial port on the bottom of the printer. See
Figure 3.
into the serial port on the bottom of the printer. See
Figure 3.
2
Connect the 9-pin serial connector to an available serial
port on your computer or device, as appropriate.
port on your computer or device, as appropriate.
3
Plug the power cord into the power adapter.
4
Plug the power adapter into the power connector on the
bottom of the printer.
bottom of the printer.
5
Insert the cables through the cable channel.
6
When all the cables are connected, plug the power cord
into an electrical outlet.
into an electrical outlet.
7
Configure the printer port with the appropriate settings.
The printer default settings are:
Baud Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Follow the instructions in "Loading Labels" on page 6 to correctly load labels onto the spool and
insert the spool into the printer.
insert the spool into the printer.
USB
10101
24VDC
Figure 3
10101
24VDC