Atlantis Land A02-IPCAM2-W54 ユーザーズマニュアル

                                                                                                           

IP Wireless Security Motorized Camera

 

A02-IPCAM2-W54_ME01

69 

 

Why does the Link LED 
not light up properly? 

•  There might be a problem with the network cable.  To 

confirm that the cables are working, PING the address 
of a know device on the network.  If the cabling is OK 
and your network is reachable, you should receive a 
reply similar to the following (…bytes = 32 time = 2 
ms). 

 

•  The network device utilized by the IP Wireless 

Security Motorized Camera is not functioning properly 
such as hubs or switches.  Confirm the power for the 
devices are well connected and functioning. 

 

• 

The wireless connection might be at fault.  In ad-hoc 
mode make sure the IP Wireless Security Motorized 
Camera wireless channel and ESS-ID is set to match 
the PC/Notebook wireless channel and ESS-ID for 
direct communication.  Under infrastructure mode 
make sure the ESS-ID on the PC/Notebook and the IP 
Wireless Security Motorized Camera must match with 
the Access Point’s ESS-ID.

 

 
 

Why does the IP 
Wireless Security 
Motorized Camera work 
locally but not 
externally? 

•  Might be caused from the firewall protection.  Need to 

check the Internet firewall with your system 
administrator. 

 
•  The default router setting might be a possible reason.  

Need to double check if the configuration of the 
default router settings is required. 

 

  
  

Why does a series of 
broad vertical white line 
appears through out 
the image? 

A likely issue is that the CMOS sensor becomes overloaded 
when the light source is too bright such as direct exposure to 
sunlight or halogen light.  You need to reposition the IP 
Wireless Security Motorized Camera into a more shaded area 
immediately as this will damage the CMOS sensor.