Toshiba GD-1160 ユーザーズマニュアル

- Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and 

direct sunlight.

- Provide proper ventilation since the equipment emits a slight amount of ozone.
- To insure adequate working space for the copying operation, keep a minimum clearance of 80 

cm (32”) on the left, 80 cm (32”) on the right and 10 cm (4”) on the rear.

- The equipment shall be installed near the socket outlet and shall be accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over 

it. 

2) General Precautions at Service

- Be sure to turn the power OFF and unplug the power cable during service (except for the service 

should be done with the power turned ON).

- Unplug the power cable and clean the area around the prongs of the plug and socket outlet once 

a year or more. A fire may occur when dust lies on this area.

- When the parts are disassembled, reassembly is the reverse of disassembly unless otherwise 

noted in this manual or other related documents. Be careful not to install small parts such as 
screws, washers, pins, E-rings, star washers in the wrong places.

- Basically, the equipment should not be operated with any parts removed or disassembled.
- The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband 

since the ICs on it may be damaged due to static electricity.

- Avoid expose to laser beam during service. This equipment uses a laser diode. Be sure not to 

expose your eyes to the laser beam. Do not insert reflecting parts or tools such as a screwdriver 
on the laser beam path. Remove all reflecting metals such as watches, rings, etc. before starting 
service.

- Be sure not to touch high-temperature sections such as the exposure lamp, fuser unit, damp 

heater and areas around them.

- Be sure not to touch high-voltage sections such as the chargers, transfer belt, 2nd transfer roller, 

developer, high-voltage transformer, exposure lamp control inverter, inverter for the LCD back-
light and power supply unit. Especially, the board of these components should not be touched 
since the electric charge may remain in the capacitors, etc. on them even after the power is 
turned OFF.

- Make sure that the equipment will not operate before touching potentially dangerous places (e.g. 

rotating/operating sections such as gears, belts pulleys, fans and laser beam exit of the laser 
optical unit).

- Be careful when removing the covers since there might be the parts with very sharp edges 

underneath.

- When servicing the equipment with the power turned ON, be sure not to touch live sections and 

rotating/operating sections. Avoid exposing your eyes to laser beam.

- Use designated jigs and tools.
- Use recommended measuring instruments or equivalents.
- Return the equipment to the original state and check the operation when the service is finished.
- Be very careful to treat the touch panel gently and never hit it. Breaking the surface could cause 

malfunctions.

3) Important Service Parts for Safety

- The breaker, door switch, fuse, thermostat, thermofuse, thermistor, IC-RAMs including lithium 

batteries, etc. are particularly important for safety. Be sure to handle/install them properly. If 
these parts are short-circuited and their functions become ineffective, they may result in fatal 
accidents such as burnout. Do not allow a short-circuit or do not use the parts not recommended 
by Toshiba TEC Corporation.

4) Cautionary Labels