Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Actiontec electronic
  4. V.90
  5. ユーザーズマニュアル

Actiontec electronic V.90 ユーザーズマニュアル

ダウンロード
ページ / 33
7
consult your computer’s user manual. Be sure to Save the settings before
exiting the BIOS Setup. The computer will then reboot. Set your modem’s
jumpers to COM 2 - IRQ 3. (See Jumper Settings in the Installing the Mo-
dem section for jumper setting diagrams.)
•
You are now ready to install the modem. Proceed to the next section.
Installing The Modem
JUMPER SETTINGS
This modem has two sets of jumper blocks used for manual COM Port and IRQ
(interrupt) selection. These are made available for users of non Plug-N-Play oper-
ating systems where the default jumper setting cannot be used. It also makes pos-
sible manual installation in a system where the installer wishes to use a specific
COM Port and IRQ. Figure 2 shows the default jumper setting for JP1 and JP2 as
shipped from the factory. This setting is for Plug-N-Play and will auto-configure
in computers with operating systems that support this feature, like Windows 95
Figure 2: Jumpers Set To Plug-N-Play (default setting)
The Jumper Block JP1 is used to select the desired COM Port for the modem.
Figure 3: shows the selections for each COM Port.
Figure 3: JP1 COM Port Options