Philips HFC 325 ユーザーズマニュアル
20
Philips · HFC 325
EN
10 Service
Fixing a paper jam
1
Open the paper tray and remove the jammed paper.
2
Insert the paper roller back again.
Fixing a Document Jam
1
Should CHECK DOCUMENT!! appear on the display,
open the paper tray as well as the panel.
open the paper tray as well as the panel.
2
Remove the jammed document.
3
Close the panel and the paper tray.
Cleaning of the roller and the
scanner
scanner
We recommend the cleaning of the roller and the scanner
every six months.
every six months.
1
Open the paper tray.
2
Open the panel.
3
Bring the two white side supports of the roller in verti-
cal position, and remove the roller.
cal position, and remove the roller.
4
Clean the surface of the scanner and the roller with a
soft, lint-free cloth.
soft, lint-free cloth.
5
Reinsert the roller.
6
Lock the roller with the two white side supports.
7
Close the panel and the paper tray.
Cleaning of the thermal print
head
head
We recommend the cleaning of the thermal print head
every six months, so that the printing quality is main-
tained.
every six months, so that the printing quality is main-
tained.
1
Open the cover for the paper tray.
2
Clean the surface of the thermal print head and the
roller with a soft, lint-free cloth.
roller with a soft, lint-free cloth.
3
Close the paper tray.
Checking the Firmware
Version
Version
1
Press OK, 47 and OK.
2
The model designation and the configured country
appear on the display.
appear on the display.
3
Confirm with OK.
4
The information on the firmware version of the device
is displayed.
is displayed.
5
Confirm with OK.
Using Service Codes
Introduction
The service codes delete all the changed settings and your
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than
expected.
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than
expected.
Using Service Codes
1
Press OK, 45 and OK.
2
Enter a service code:
7117
—Deletes all changed settings and
saved data. The device is reset to factory settings and
the initial installation process is started.
the initial installation process is started.
7140
—Deletes all changed settings. Saved
data and telephone book entries remain intact.
7227
—Deletes saved faxes, when there are
problems with printing.
3
Confirm with OK.
4
Use [ to select SURE: YES.
5
Confirm with OK.
CAUTION!
Settings will be Deleted!
Only use the service codes if this is absolutely
necessary. Some service codes also delete saved
messages and telephone book entries.
Only use the service codes if this is absolutely
necessary. Some service codes also delete saved
messages and telephone book entries.
Notice
Cancelling Entry
If you have entered the incorrect code, you
can cancel the entry with SURE: NO.
If you have entered the incorrect code, you
can cancel the entry with SURE: NO.
hfc 325-manual-en-253327723-a.book Seite 20 Montag, 6. September 2010 9:34 09