Multi-Tech Systems MT5634SMI V.92 ユーザーズマニュアル
Chapter 2 – Fax Class 1 and 1.0 Commands
Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C)
39
Result Codes:
CONNECT – Reported when the modem begins the training sequence after
receipt of a valid <mod> value.
receipt of a valid <mod> value.
ERROR – If the modem transmit buffer becomes empty and the last
transmitted character is NUL (00), the modem continues to transmit NULs
until the DTE sends more data or five seconds elapses. After five seconds
elapse with an empty transmit buffer, the modem will turn off the transmit
carrier, return to the command state, and report the ERROR result code.
transmitted character is NUL (00), the modem continues to transmit NULs
until the DTE sends more data or five seconds elapses. After five seconds
elapse with an empty transmit buffer, the modem will turn off the transmit
carrier, return to the command state, and report the ERROR result code.
OK – If the modem’s transmit buffer becomes empty and the last transmitted
character is not NUL, the modem will turn off the transmit carrier, return to the
command state, and report the OK result code.
character is not NUL, the modem will turn off the transmit carrier, return to the
command state, and report the OK result code.
Reporting Current or Selected Values:
Command:
+FTM?
Response: +FTM: <mod>
Example: +FTM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
Command:
+FTM=?
Response: +FTM: (<mod> range)
Example: +FTM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Command: +FRM Receive
Facsimile
Description:
This command causes the modem to enter the receiver mode using the
modulation defined below.
modulation defined below.
Defined Values:
<mod> Decimal number corresponding to the selected modulation mode and
data rates shown in Table 3-2.
data rates shown in Table 3-2.
Reporting Current or Selected Values:
Command:
+FRM?
Response: +FRM: <mod>
Example: +FRM: 98 for V.17 9600 bps.
Reporting Supported Range of Parameter Values:
Command:
+FRM=?
Response: +FRM: (<mod> range)
Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes:
CONNECT – Reported when the selected carrier is detected.
+FCERROR – Reported if another carrier is detected and FAR=0; the modem
then returns to the command state.
then returns to the command state.
NO CARRIER – Reported if loss-of-carrier is detected.
OK – Reported if the DTE sends any character to the modem other than XON
or XOFF while operating in configured flow control from the DTE; the modem
then returns to the command state.
or XOFF while operating in configured flow control from the DTE; the modem
then returns to the command state.