Multi-Tech Systems MT9234ZBA-USB ユーザーズマニュアル

Appendix D – Linux Installations 

36 

Multi-Tech Systems, Inc. MT9234ZBA-USB User Guide (S000419D)

 

You will need the TI USB tgz package for this step.  The Introduction section above describes where to find the latest TI USB tgz 
package. 

Log in as root and do the following: 

 

1. tar xvzf ti_usb-X.Y.tgz 

Un-package the files. 

2. cd ti_usb-X.Y 

 

3. ./configure 

Configure the package for your distribution and kernel. 

4. make 

Build the driver. 

5. make install 

Install the ti_usb driver. 

 

If there are problems in this process, you may need to go back to install and prepare the kernel sources as described above. 

 

The ti_usb driver should be automatically loaded when you plug in the TI USB 3410 device, provided your device uses the 
default vendor and product ids.  If it does not, see the section entitled "VENDOR and PRODUCT IDS" in the Release Notes file 
for Linux 2.4 kernel installations (on the product CD as file name ti_usb_release_notes-1 2.txt). 

The first TI USB 3410 device plugged in will appear as /dev/ttyTIUSB0, the next as /dev/ttyTIUSB1, and so on. 

Note that these device names are different from the device names used by the Linux usbserial driver.  See the section below 
entitled "DEVICE FILES" for more information. 

If TI USB devices had been in use before installing the new TI USB driver, old versions of the drivers will still be loaded. These 
old versions must be unloaded before the newly installed driver will be used. 

The simplest way to unload the old drivers and load the new is to reboot. 

Alternatively, you can close all open TI USB serial ports, disconnect the TI USB serial devices, and then unload the old TI USB 
serial driver with the command 

     rmmod ti_usb 

 

  Then reconnect the TI USB serial devices and the new driver will be loaded.