Multi Tech Equipment ISIHI-2S ユーザーズマニュアル

To store a telephone number, type 

 in terminal mode, where 

n

 is the number of the

memory register in which the number is to be stored, and 

x

 is the dial command string

that you want to store. For example, type AT&Z9=612-785-3500 <cr> to store the
number 612-785-3500 in memory register 9.

To dial a stored telephone number, type 

 in terminal mode, where 

n

 is the location

of the number you wish to dial. For example, type ATDS=3 <cr> dials a telephone stored
in memory register 3 location.

To display a stored telephone number, type 

 in terminal mode, where 

n 

is the

memory register in which the number is stored. For example, type AT&Z5? <cr> to
display the telephone number in memory register 5. To list all ten telephone numbers
stored in memory, type ATL <cr>.

You can answer incoming calls to the TA either manually or automatically. When the TA
detects an incoming call, it turns on the RI signal on the V.24 interface and sends a 

RING

result code to the computer or terminal after each ring. If autoanswer is enabled, the TA
automatically answers the call. To manually answer the call, use the 

 command.

If your communication program is in terminal mode when the 

RING

 result code appears

on your monitor, manually answer the call by typing 

.

To cause the TA to answer a call automatically :

1. Enable autoanswer by setting register 

 to the ring on which you want the TA to

answer (e.g., in terminal mode, type 

 to make the TA answer on the fourth ring).

Youalso  can use one of the configuration utilities to the turn autoanswer on and set
the number of rings.

2. Make sure that the TA is offline.

The TA will answer the call after the number of rings specified by 

. To disable

autoanswer, use a configuration utility or the command 

.

Note: If the user wants to accept calls while DTR is low, the TA must be configured to
ignore DTR. To ignore, enter AT&D0<cr>. With this configuration, the TA can accept calls
while DTR is low. If this configuration setting is not made, the TA rejects incoming calls
until DTR is high while the calls comes in.

To hang up a call, first escape to online command mode (

), then enter the 

command (

). The escape sequence and hang up command can be combined

into one command string: 

.