Enfora MLG0208PB001 ユーザーズマニュアル

ページ / 82
Enfora Enabler II-G Assisted GPS 
Modem Integration Guide 
 
7. GSM/GPRS Modes of Operation 
 
GSM/GPRS supports many optional services and modes.  The Enfora Enabler II-G A-GPS module 
supports the following GSM/GPRS services: 
 
• 
Circuit-switched data 
 
• 
Short-Message Services (SMS) 
 
• 
Class B GPRS Functionality 
 
•  Voice communication 
 
7.1.  Enabling the Transmission Modes for the GSM/GPRS Services 
 
Each of the GSM/GPRS services has two modes that can be enabled separately: 
 
• 
Mobile-originated (MO): allows the making of a service request (such as, making a telephone call 
or sending an SMS) 
 
• 
Mobile-terminated (MT): allows receiving a service request (such as receiving a telephone call or 
an SMS) 
 
Note: 
Contact your local GSM operator to ensure that the services and modes have been 
provisioned for the SIM. 
 
7.2. Voice Communication 
 
The Enfora Enabler II-G A-GPS module has full voice capabilities, provided the necessary 
connections have been made for the speaker and microphone pins on the 60-pin I/O connector.  The 
Enfora Enabler-IIG AT Command Set Reference - GSM0107PB001MAN has the entire list of 
commands that can be used to control the voice functionality.  The quick start guide in this manual 
provides a basic command set that can be used to initialize and test the voice functionality. 
 
The Enfora Enabler II-G A-GPS module supports three vocoder compression algorithms for voice 
communication: Full-Rate (FR), Enhanced Full-Rate (EFR), and Half-rate (HR). 
 
7.3. Circuit-Switched Data 
 
In this mode, the Enfora Enabler II-G A-GPS module supports both of the connection modes of 
transmission that are provided by GSM: 
 
• 
Non-Transparent mode delivers a constantly low error rate but with a non-guaranteed throughput 
or delay.  The Non-Transparent service provides a performance that is closest to using a modem 
over a fixed Public Switched Telephone Network (PSTN) line. 
 
Note: 
All GSM service providers may not support transparent mode.  In those cases, the Enfora 
Enabler II-G A-GPS module can be configured to switch automatically to Non-Transparent mode.  
This capability depends on the settings in the AT+CBST command. 
 
MLG0208PB001 
40 
Version1.01 – 10/3/2006