MRV Communications TS5000/4U1/V*) ユーザーズマニュアル

M R V   C o m m u n i c a t i o n s ,   I n c .   –   I n s t a l l a t i o n   M a n u a l  

3 

M (for Multimode) 

S (for Single Mode) 

‘Y’ represents operating wavelength. 
 

Instead of Y use one of the following: 

8 (for 850 nm) 
3 (for 1310 nm) 

5 (for 1550 nm) 

‘Z’ represents connector type. 
 

Instead of Z use one of the following: 

C (for SC) 
T (for ST) 

‘V’ represents yes or not with Fusion. 

 

Instead of V use one of the following: 

V represents no built-in Fusion option. 

F represents built-in Fusion option. 

Power Supply: Each product base code ends with * or **.  * means that the 
product has one power supply. **means that the product can have two power 

supplies: one main and the other one - for back-up. In the products description, 
there is a list of all compatible power supplies. When ordering, please specify the 
required power supply and make sure that it is in the above list. For example, if a 

TS5000/155 with one power supply, high voltage (100-240VAC) is required; 
TS5000/XYZ/V1S should be ordered. Similarly, in case of 2 power supplies low 

voltage (35-60VDC), the p/n will be TS5000/XYZ/V23. If the required product 
can have only one power supply, for example TS5000/ETH, high voltage, the 
p/n will be TS5000/ETH/VS. 

‘S’ represents power supply type 
 

Instead of S use one of the following: 

S (for input to the power supply in the range 100-240 VAC) 

3 (for input to the power supply in the range 35-60 VDC) 

‘U’ represents telephony protocol type. 

 

Instead of U use one of the following: 

E (for E1) 
T (for T1) 

 

1.   Front

 

Each unit comprises a receiver, 3 transmitters and an interface on the rear panel for 
the connection to the peripheral equipment. 

 

 

Front view 
Showing the receiver 

side, the transmitters and 

the telescope 

Telescope

Transmitter

 

Receiver

Transmitters

 

AVOID EXPOSURE – 
INVISIBLE LASER 
RADIATION IS EMITTED 
FROM THIS APERTURE