MRV Communications TS5000/XXX (TS5000G/XYZ/V** ユーザーズマニュアル

M R V   C o m m u n i c a t i o n s ,   I n c .   –   I n s t a l l a t i o n   M a n u a l  

18 

Table 4: TS5000/ETH Model Back Panel Controls, Interfaces, and Indicators

 
Note:  Pins (4,5) of the main RJ45 connector can be used for dry contact purposes, for 
Airlink flag alarm.

 

 
 

Air RX Link LED 

Green LED indicates that a signal is received by the 

Airlink receiver. Switches ON at the threshold level 
 

Air RX Data LED 

Yellow LED indicates Data  transfer through  the 

Airlink receiver 
 

10Base-T Link LED 

Green LED indicates a signal is received by the 

10BaseT interface. Switches ON at the threshold 
level 

 

10Base-T Data LED 

Yellow LED indicates Data  transfer through  the 
10BaseT interface 

 

Indicators  
(7-segment 
display, LEDs) 

Optical Power 7-
segment display 

Digital readout indicates in mV the Optical Power 
level received by the Airlink receiver 

 

 
 

 

Power

Power source Terminal Block (Main or UPS). 
AC power supply (100 to 240 Vac) or DC power 

supply (35 to 60 Vdc) 

10Base-T 

 

Copper interface (RJ45) for STP cables.  
MDI-X connection. 

Remote Monitor 

Connection to an optional Remote Status 

Monitor or to RSM-DC (for Dry Contact 
connection) (not included in the standard 

transceiver kit)  

 

Management 
(10baseT) 

Connection to 10Base-T SNMP management 
interface.  Pins 1,2: TX and 3,6 RX. 

 

IP address set up  

When the Switch toggle is on OFF position, the 
TereScope’s IP address is the default one (shown 

on the back panel label: 10.0.0.101). To set a new 
IP address, please refer to the “IP address setting 

procedure for TereScope management card” file 
in the Manuals CD. The new IP address is valid 

only after the TereScope is powered off and on. 

 

 

Fusion 

This switch enables working with MRV’s Fusion 
system. For additional info see page 8 Toggle 

#10 OFF: Fusion Non Active:  
Toggle #10 ON: Fusion active.