ONKYO ABX-N300 ユーザーズマニュアル
En-
8
Using the Remote
Controller
Controller
Remove the plastic film before using the remote controller.
When using the remote controller, point it toward the
ABX-N300’s remote control sensor, as shown below.
ABX-N300’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
• The remote controller may not work reliably if the
ABX-N300 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
• If another remote controller of the same type is used in
the same room, or the ABX-N300 is installed close to
equipment that uses infrared rays, the remote
controller may not work reliably.
equipment that uses infrared rays, the remote
controller may not work reliably.
• Don’t put anything, such as a book, on the remote
controller because the buttons may be pressed
inadvertently, thereby draining the batteries.
inadvertently, thereby draining the batteries.
• The remote controller may not work reliably if the
ABX-N300 is installed in a rack behind colored glass
doors. Keep this in mind when installing.
doors. Keep this in mind when installing.
• The remote controller will not work if there’s an
obstacle between it and ABX-N300’s remote control
sensor.
sensor.
Replacing the Battery
1
While sliding the stopper to the side, pull
out the battery holder.
out the battery holder.
2
Insert a lithium button battery in the battery
holder, and then replace the holder.
holder, and then replace the holder.
When replacing the battery
When you replace the battery, be sure to use the specified
type of battery.
When you replace the battery, be sure to use the specified
type of battery.
Notes:
• If the remote controller doesn’t work reliably, try
• If the remote controller doesn’t work reliably, try
replacing the battery.
• If you intend not to use the remote controller for a long
time, remove the battery to prevent damage from
leakage or corrosion.
leakage or corrosion.
• Expired batteries should be removed as soon as
possible to prevent damage from leakage or corrosion.
• Make sure that the battery is oriented in the correct
polarity (observe the “+” and “–” indication).
• Never use a battery of a different model number.
• If not handled correctly, a lithium battery may ignite
• If not handled correctly, a lithium battery may ignite
or chemically cause skin irritation. Keep lithium
batteries out of the reach of children.
Do not disassemble, recharge, or incinerate a lithium
battery, and do not allow it to reach a temperature
exceeding 100 °C (212 °F). When replacing the
battery, use only the specified type of battery. If you
use the wrong battery, you risk causing fire or
explosion.
batteries out of the reach of children.
Do not disassemble, recharge, or incinerate a lithium
battery, and do not allow it to reach a temperature
exceeding 100 °C (212 °F). When replacing the
battery, use only the specified type of battery. If you
use the wrong battery, you risk causing fire or
explosion.
ABX-N300
30°
30°
Remote control sensor
Approx. 5 m
(16 ft.)
(16 ft.)
Back side
Positive (+) side
Required battery
3V lithium button battery
CR2025
3V lithium button battery
CR2025
Battery holder
Polarity
indication
indication
Battery model
number
number
Latch