Motorola CPCI-6020 ユーザーズマニュアル
Jumper Settings
Hardware Preparation and Installation
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
41
z
Remote switch (J19)
z
Jumpers J7 and J25 are only for factory use
2.8
Jumper Settings
The following sections describe the on-board jumpers and their configurations for the CPCI-
6020. For jumper locations, see
6020. For jumper locations, see
2.8.1
Flash Bank Selection
The CPCI-6020 contains one bank of 32 MB 16-bit flash memory soldered on-board (Bank A)
and 1 MB of 16-bit socketed flash memory (Bank B). Bank A is 64-bits wide and Bank B is 16-
bits wide. Bank B contains the on-board debugger and diagnostics, PPCBug.
and 1 MB of 16-bit socketed flash memory (Bank B). Bank A is 64-bits wide and Bank B is 16-
bits wide. Bank B contains the on-board debugger and diagnostics, PPCBug.
Figure 2-1
Header Locations and Jumper Settings
J22
U19
U18
U31
1
3
J24
J20
J21
J17
J19
J18