Motorola CPCI-6020 ユーザーズマニュアル

3. Carefully remove the CPCI-6020 from the CompactPCI card slot and place it on a 

clean and adequately protected working surface with connectors J1 through J5 
facing you.

4. Remove the PCI filler from the front panel.

5. Slide the edge connector of the PMC module into the front panel opening from 

behind and place the PMC module on top of the baseboard. The four connectors on 
the underside of the PMC module should then connect smoothly with the 
corresponding connectors (J11/12/13/14) on the CPCI-6020.

6. Insert the four short phillips-head screws (provided with the PMC) through the holes 

on the bottom side of the CPCI-6020 and the PMC front bezel and into rear 
standoffs. Tighten the screws.

7. Reinstall the CPCI-6020 assembly in its proper card slot. Be sure the module is well 

seated in the backplane connectors. Do not damage or bend connector pins.

8. If the PMC module was installed in a non-hot swap chassis, replace the chassis or 

system cover(s), reconnect the system to the AC or DC power source and turn the 
equipment power on.