Motorola VC5090 ユーザーズマニュアル

Staging and Provisioning

8 - 7

When staging is complete the 

 window displays.

Press the left function key to exit the 

.

The MSP 3.X 

 also enables staging without having to scan bar codes through the use of On-Demand 

Staging (Electronic Staging).

When using On-Demand Staging, the RD Client pulls staging profiles directly from an On-Demand Profile Server 
over some form of pre-configured or automatically-configured IP connection. The following types of IP connection 
modes are currently supported for Electronic Staging:

This mode uses the IP connection that is established when the mobile computer is directly connected (via a USB 
cable, serial cable or cradle) to a host computer running ActiveSync. The most common scenario would be where 
the On-Demand Profile Server is running on the host computer to which the mobile computer is connected via 
ActiveSync. It would, however, also work with the On-Demand Profile Server running on any other host computer 
that is on the same subnet as the host computer to which the mobile computer is connected via ActiveSync.

This mode uses any IP connection that is already active on the mobile computer. This could be a direct Ethernet 
port (if available), or a WLAN connection that was configured and established before the 

 was launched. It 

could also be any other form of IP connection that might be available on the mobile computer. The 

 does 

not do anything to configure or establish such connections, but uses them if they exist. The On-Demand Profile 
Server must be running on a host computer that is on the same subnet that is accessible from the connection.