Motorola VC5090 ユーザーズマニュアル

ページ / 258
2 - 38 VC5090 Vehicle Computer Product Reference Guide
timer is running, the touch screen is enabled but the backlight and keyboard are still disabled. If during this time the 
user touches the screen, the backlight comes on and the vehicle computer unlocks fully. Otherwise after this timer 
expires, the backlight comes on and the vehicle computer unlocks fully. If, while any of these timers are running, 
the vehicle pedal is pressed, the vehicle computer locks again.
If the cable is cut or removed, the vehicle computer responds as if the pedal is depressed.
Switches
There are two types of switches that can be used; a solid state switch and a mechanical switch. Typically solid 
state switches have a much longer life cycle than mechanical switches. Solid state switches require power while 
mechanical switches do not.
The switch must be rated at 5V, 10 mA and it should have a operating temperature, sealing and life cycle 
applicable for the environment that it is used in.
The mechanical switch must be a Normally Open type of switch.
The supply voltage for the solid state switch is 5 VDC (500 mA max.). When the switch is depressed the OUT pin is 
pulled low.
The switch must be mounted permanently and must be positioned in such a way so that the switch is depressed 
when the accelerator pedal is not pressed (vehicle at rest). When the accelerator pedal is pressed, the switch 
should open and stay open until the pedal is released completely.
Figure 2-55    
Switch Installation Example (Switch Normally Closed)
Switch (Closed)
Accelerator 
Pedal
Switch (Open)
Accelerator 
Pedal
Mounting 
Hardware
Mounting 
Hardware
Cable
Cable
Vehicle Stationary
Vehicle In-Motion
Note: Diagram is for concept only. Actual switch, pedal, mounting hardware and installation vary depending upon the 
type of vehicle and hardware used.