HP (Hewlett-Packard) D3K33UT#ABA ユーザーズマニュアル

All display assemblies include WLAN antenna transceivers and cables. WWAN models also include 2

WWAN antenna transceivers and cables.

Full hinge-up displays are not spared.

This section describes removing components that do not require that you entirely remove the display

assembly from the computer. You can remove the display bezel, webcam/microphone module, and

display panel with the display assembly still attached to the computer.

To remove the remaining display components, including the display brackets, antennas, and enclosure,

you must remove the entire display assembly from the computer. See 

for more information about removing the remaining components.

35.6-cm (14.0-in), HD+, anti-glare, LED

708771-001

35.6-cm (14.0-in), HD anti-glare, LED

702871-001

 

For use with models with a webcam

702860-001

For use with models without a webcam

702861-001

702854-001

702873-001

Before removing the display panel, follow these steps:

Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

Disconnect all external devices connected to the computer.

Disconnect the power from the computer by first unplugging the power cord from the AC outlet,

and then unplugging the AC adapter from the computer.

Remove the battery (see 

Remove the display assembly components:

Position the computer upright, with the front toward you.

Open the computer as far as possible.

If it is necessary to replace the display bezel or any of the display assembly subcomponents:

a. Flex the inside edges of the bottom edge (1), the left and right sides (2), and the

top edge (3) of the display bezel until the bezel disengages from the display enclosure.

Component replacement procedures

43