HP (Hewlett-Packard) D8C07UTABA ユーザーズマニュアル
3.
Release the RJ-11 jack cable from the clips (2) and routing channel built into the base enclosure.
4.
Remove the RJ-11 jack cable.
Reverse this procedure to install the RJ-11 jack cable.
Service cover release latch assembly
NOTE:
The service cover release latch assembly components are included in the Latch Kit, spare part
number 684339-001.
Before removing the service cover release latch assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
), and then remove the following components:
a.
Service cover (see
)
b.
Smart Card reader (see
c.
Optical drive (see
)
d.
e.
)
f.
Keyboard (see
g.
)
86
Chapter 4 Removal and replacement procedures