HP (Hewlett-Packard) ZT1000 ユーザーズマニュアル
zt1000/xz300 and xt1500 Series
Removing and Replacing Parts
41
Troubleshooting and Self-Repair Guide
Figure 11. Removing the Hard Disk Tray
Reassembly Notes
• Insert the connector end of the drive through the opening in the tray, then lower the drive into
place.
• Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software—see “Recovering the Factory Software Installation”
on page 35.
drive before loading any additional software—see “Recovering the Factory Software Installation”
on page 35.
Screws,
M2.5x4mm (2)
M2.5x4mm (2)
Screws,
M2.5x4mm (2)
M2.5x4mm (2)