Apple EPR2320TM ユーザーズマニュアル

ページ / 81
WebSTAR DPR2320 and EPR2320 Gateway Cable Modems User’s Guide 
12 
 
To install the gateway cable modem 
 
1. 
Power down your PC and unplug it from the power source. 
2. 
Connect your PC to either the ETHERNET port or the USB port using the 
appropriate data cable. Do not connect your PC to both the Ethernet and 
USB ports at the same time. You can connect two separate PCs to the 
gateway cable modem at the same time by connecting one PC to the 
Ethernet port and one PC to the USB port. 
3. 
Connect the active RF coaxial cable to the CABLE connector. Use an 
optional cable signal splitter to add a TV, a DHCT or set-top converter, or 
a VCR. 
4. 
Insert the AC power adapter cord into the DC POWER connector on the 
back of the gateway cable modem, and then plug the power adapter into 
an AC power source. 
5. 
Plug in and power on your networked devices including your PC. The 
gateway cable modem will then begin an automatic search to locate and 
sign on to the broadband data network. This process may take up to 5 
minutes. The modem will be ready for use when the CABLE indicator on 
the front panel stops blinking and illuminates continuously. 
6. 
The next step in setting up your gateway cable modem is to configure 
your Internet devices for Internet access. Choose one of the following 
options: 
•  If you want to use Ethernet connections, you must configure the 
TCP/IP protocol. To configure the TCP/IP protocol go to How Do I 
Configure TCP/IP Protocol, next in this guide. 
•  If you want to use USB connections, you must install the USB drivers. 
To install the USB Drivers for USB go to How Do I Install USB 
Drivers
, later in this guide. 
 
 
 
 
WARNING
To avoid personal 
injury or damage to 
your equipment, 
follow these steps in 
the exact order shown.