Apple EPR2320TM ユーザーズマニュアル

 

 

 

1. Click 

the 

Apple icon in the upper left corner of the Finder. Scroll down to 

Control Panels, and then click TCP/IP. 

2. Click 

Edit on the Finder (gray bar) at the top of the screen. Scroll down to 

the bottom of the menu, and then click User Mode. 

3. Click 

Advanced in the User Mode window, and then click OK. 

4. Click 

the 

Up/Down selector arrows located to the right of the Connect Via 

section of the TCP/IP window, and then click Using DHCP Server. 

5. Click 

Options in the TCP/IP window, and then click Active in the TCP/IP 

Options window. 

Note:  In some cases, the Load only when needed option will not 
appear. If it appears, select the option. A check mark appears in the 
option. 

6. 

Verify that the Use 802.3 option located in the upper right corner of the 
TCP/IP window is unchecked. If there is a check mark in the option, 
deselect the option, and then click Info in the lower left corner. 

7. 

Is there a Hardware Address listed in this window? 
• If yes, click OK. To close the TCP/IP Control Panel window, click File, 

and then scroll down to click Close. You have completed this 
procedure. 

• If no, you must power off your Macintosh. 

8. 

With the power off, simultaneously press and hold down the Command 
(Apple), Option, P, and R keys on your keyboard. Keeping those keys 
pressed down, power on your Macintosh but do not release these keys 
until you hear the Apple chime. 

9. 

Continue pressing these keys for at least three chimes, then release the 
keys and allow the computer to restart. 

10. 

When your computer fully reboots, repeat steps 1 through 7 to verify that 
all TCP/IP settings are correct. If your computer still does not have a 
Hardware Address, contact your authorized Apple dealer or Apple 
technical support center for further assistance.