Apple EPR2320TM ユーザーズマニュアル

 

 

Read the warnings and caution on this page. Then, follow the subsequent 
installation procedures to ensure proper gateway cable modem operation when 
connecting USB network devices. 

 Verify that you have installed the USB drivers on your PC before continuing 

with these instructions. See How Do I Install USB Drivers, earlier in this guide 
for more information on installing the USB drivers. 

 

1. 

Select locations for USB network devices. For more information, see 
How Do I Select and Place USB Network Devices, earlier in this guide. 

2. 

Connect the USB port on the gateway cable modem to your computer. 

3. 

Connect one or more USB network device to the gateway cable modem. 

 

If you want to connect more than one USB network device to the 

gateway cable modem or to your computer, you will need to purchase 
and install a USB hub. 

4. 

Connect the active RF coaxial cable to the CABLE connector on the back 
of the gateway cable modem. Use an optional cable signal splitter to add 
a TV, a DHCT or set-top converter, or a VCR. 

5. 

After all connections are complete, insert the AC power adapter cord into 
the DC POWER connector on the back of the gateway cable modem, and 
then plug the power adapter into an AC power source. 

6. 

The gateway cable modem begins an automatic search to locate and 
sign on to the network that provides the telephone service. This process 
may take up to 5 minutes. The gateway cable modem is ready for use 
when the CABLE status indicator on the front panel stops blinking and 
illuminates continuously. 

7. 

Verify that all USB devices are working properly. 

 

You will not be able to check the USB front panel status indicator 

on the gateway cable modem until after at least one USB network device 
is connected and operating on the network. 

 
 
 
 

 

•  Hazardous electrical 

•  To avoid personal