Chaparral G5312/G7313 ユーザーズマニュアル

G- and K-Series User’s Guide

2-2

To connect to the Fibre Channel port:

Be sure the enclosure power is turned off.

Connect one end of the Fibre Channel cable to the FC port on the enclosure.

Connect the other end of the Fibre Channel cable to a server’s HBA or to an
arbitrated loop hub or fabric switch.

Turn power on and begin configuration.

Connecting to the RS-232 Port

You use the RS-232 port to update the firmware, configure, and monitor the
controller using a VT-100/ANSI computer with a terminal emulator.

Refer to your enclosure documentation for information about the correct type of cable
to use. Use a 9-pin straight-through cable. A null modem cable does not work.

Configure the RS-232 port in your terminal emulator software using the following
settings:

Baud rate: 9600, 19200, 38400, 57600, or 115200; 115200 best for
downloading firmware upgrades

Data Bits: 8

Stop Bits: 1

Parity: None

Flow Control: None or XON/XOFF.

9 Pin Female

D SUB

9 Pin Female

D SUB