Carrier Access Axxius 800 ユーザーズマニュアル
5-170
Axxius 800 - Release 2.2
CLI Commands
set
set (v35)
Use the set (v35) command to setup V.35 ports. The command specifies the range of channels
within that card, and the setting to apply.
within that card, and the setting to apply.
Syntax:
set {v35-addr} {setting}
Example:
set 6:1 rxclk normal
To set port 1 (v.35) on slot 6 to no inversion on the receive clock
{v35-addr}
In the form of {slot:port}.
{setting}
Setting to apply one of the following:
slot
Slot number (1-8) of the Axxius chassis where the V.35 card is located
port
Port number or range.
clock
Set the clock source to one of the following:
external
to the external source
source
to the internal Stratum 4E oscillator
cts
Set the Clear To Send operation mode to one of the following:
cd
follow CD
high
force CTS high
low
force CTS low
rts
follow RTS
data
Set the data mode to one of the following:
invert
invert the receive and transmit data
normal
do not invert receive and transmit data
equipment
Sets the V.35 port to equipment loopback, which loops the transmit V.35
signal back toward the V.35 receive (toward the T1)
signal back toward the V.35 receive (toward the T1)
loopdown
disable equipment loopback
loopup
enable equipment loopback
line
Sets the V.35 port to line loopback, which loops the received V.35 signal
back toward the V.35 signal toward the V.35 transmit (away from T1)
back toward the V.35 signal toward the V.35 transmit (away from T1)
loopdown
disable line loopback
loopup
enable line loopback
rxclkinv
Set the receive clock invert mode to one of the following:
invert
invert the receive clock
normal
do not invert the receive clock