Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Cabletron Systems
  4. 9E106-06
  5. ユーザーズマニュアル

Cabletron Systems 9E106-06 ユーザーズマニュアル

ダウンロード
ページ / 40
 
Installing the 9E106-06 Module
2-4
 
Installing the EPIM
 
To install an EPIM:
1. Remove the coverplate or the EPIM (whichever applies).
2. Slide your new EPIM into place, making sure the connectors on the rear of the 
module and inside the HUB attach properly. Refer to Figure 2-3.
3. Install the mounting screw.
 
Table 2-1. EPIM Board Revisions 
 
EPIM 
EPIM BOARD REVISION
 
EPIM-T
04 or greater
EPIM-F2
05 or greater
EPIM-F1
05 or greater
EPIM-F3
02 or greater
EPIM-C
05 or greater
EPIM-A
Not Applicable
EPIM-X
02 or greater
When removing an EPIM, make sure to pull the module straight out so as not to 
damage the connector.
NOTE