Cabletron Systems HSIM-G01 ユーザーズマニュアル

Connecting to the Network

HSIM-G01/G09 User’s Guide

2-9

To remove the SC connector, from the HSIM-G, carefully pull the
connector out of the port. It may need to be wiggled gently to release the
latching keys.

If a link has not been established, refer to

Chapter 3

before contacting

Cabletron Systems. Refer to

Section 1.3

for details on getting help.

2.3.2

HSIM-G09 Connection Using Multimode Cable

To connect the HSIM-G09 to the network using multimode fiber, perform
the following steps:

Connect Launch Mode Conditioning cable to the multimode fiber on
both ends of the premises cable before connecting the HSIM-G09 to
the premises cabling. See

Figure 2-5

Figure 2-5

Launch Mode Conditioning Cable Connection for the HSIM-G09

Once the Launch Mode Conditioning cable is connected to the ends of
the premises multimode fiber cable, return to

Section 2.3.1

complete the installation to the HSIM-G09 device.

NOTE

When using premises multimode fiber cable for the HSIM-G09
(long wave length transceiver), connect Launch Mode
Conditioning cable as detailed in the following procedure. This
procedure is not needed when connecting single mode fiber
cable to the HSIM-G09. Do not attach Launch Mode
Conditioning cable if the installation is not using an HSIM-G09
with multimode fiber cable.

Launch Mode Conditioning cable is available through Cabletron
Systems.

Installed premises
multimode fiber cable

Long Wavelength
Gigabit Fiber Device

Launch Mode
Conditioning
Cable

Long Wavelength
Gigabit Fiber Device

mmfLWct

Connect the ends of the
premises cabling to the
Launch Mode
Conditioning Cables