Canon AXIS 1650 ユーザーズマニュアル

64

AXIS 1650 User’s Manual

AXIS CAPT Print Monitor uses broadcast communication, so that status 

information from the print server can be shared between several users 

without elevating network traffic. 

Broadcast communication is used by default in the print server.

In some networks where broadcast communication isn’t preferred, unicast 

communication can be used, which will also increase the network load. 

To enable unicast communication, some settings must be configured in 

the AXIS 1650 and in the AXIS CAPT Print Monitor during the software 

installation.

Enable Unicast via the

Web Interface

Using firmware 2.00 or later you can use your browser to enable unicast 

network communication. Open the Web interface of the print server. 

Select Admin | Network Settings | Detailed View. The TCP/IP tab will 

open. Under CAPT Port Settings, set Unicast Communications Mode to 

Yes. Click OK to save the setting. 

Go on to Install the AXIS CAPT Print Monitor on page 66.

Enable Unicast using

FTP

Follow these steps to enable unicast network communication using FTP: 

1. Open a command prompt and change to a directory where you can store 

the configuration file by typing 

C:/<any directory> and press Enter.

2. Log in to the AXIS 1650 with the command:

ftp <IP address> 
where <IP address> is the IP address of your AXIS 1650.

3. You will be prompted for a user id: 

default user id = 

root (if the default password has been changed then it must 

also be entered)

4. To access the configuration file, type: 

5. Next go to the C: directory on your computer and locate the file named 

config.

6. Open the config file using any text editor.

Important: All network configuration must be performed by the network 

administrator!