Abocom WUG2700 ユーザーズマニュアル

 

The United States Federal Communication Commission (FCC) and the 
Canadian Department of Communications have established certain rules 
governing the use of electronic equipment. 

This device complies with Part 15 of FCC rules. Operation is subject to the 
following two conditions: 

1) This device may not cause harmful interface, and 

2) This device must accept any interface received, including interface that may 

cause undesired operation. This equipment has been tested and found to 
comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy, and if not installed 
and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio  or television reception, which can be 
determined by turning off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 

ω Reorient or relocate the receiving antenna. 
ω Increase the distance between the equipment and receiver. 
ω  Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected. 

1)  To comply with FCC RF exposure compliance requirements, a separation 

distance of at least 20 cm must be maintained between the antenna of this 
device and all persons. 

2)  This transmitter must not be co-located or operating in conjunction with 

any other antenna or transmitter.