Abocom FE2000VX ユーザーズマニュアル
HARDWARE INSTALLATION
1. Hold the CardBus PC Card with wide
connector toward the slot and the brand label
facing upward.
facing upward.
2. Insert the CardBus PC Card and push it firmly
into the bottom. (Please see the following
figure for reference)
figure for reference)
N otebook
Po
we
r
LI
N K
A
C T
3. Connect the RJ-45 port of the CardBus 10/100
Ethernet PC Card Adapter to a Category 5
Network cable before loading any network
driver.
Network cable before loading any network
driver.
For operation in the 100Mbps (100Base-TX)
Ethernet network, a Category 5 unshielded
twisted pair (UTP) cable should be used to
connect between the RJ-45 port and a 100Mbps
hub or switch.
twisted pair (UTP) cable should be used to
connect between the RJ-45 port and a 100Mbps
hub or switch.
For operation in the 10Mbps (10Base-T)
Ethernet network, a Category 3, 4 or 5
unshielded twisted pair (UTP) cable could be
used to connect between the RJ-45 port and a
10Mbps hub or switch.
unshielded twisted pair (UTP) cable could be
used to connect between the RJ-45 port and a
10Mbps hub or switch.
- 1 -