Sanyo POA-PN40 ユーザーズマニュアル

PJ-NET ORGANIZER

OWNER'S MANUAL

Network configuration

Click  Network  on  the  main  menu. The  following  setting  page  is  dis-
played. This  page  is  to  set  the  IP  Address,  Subnet  Mask,  Default 
Gateway, DNS (Domain Name Server) and projector name.

The  IP  address  and  Subnet  Mask  have  been  configured  already  in  chapter 
"Installation". If you want to change them or configure default gateway or DNS, per-
form  them  in  this  page.  Enter  an  applicable  address  number  onto  each  parameter 
and click Set button.
The Network Unit begins restarting and it takes about 20 seconds. Close (Quit) the 
web browser and access to the login page again in 20 seconds. 

*1 Set [0.0.0.0] if the network does not provide the gateway (router).
*2 Set [0.0.0.0] if you do not use the function E-Mail alert.
*3  If you use the DNS server, register the host name registered to the DNS server as a projector 

name. You can access with this projector name from any computers in your network. If you 

do not use the DNS server, access with the assigned IP address to the projector.

* All the network setting will reset to the default when setting [0.0.0.0] of the IP Address.

IP address

 .........Sets IP address of the projector

Subnet mask

 ......Sets Subnet mask. Normally sets 255.255.255.0

Default gateway

*

1

 ...Sets IP address of the default gateway (Router)

DNS

*

2

 ................ Sets IP address of the DNS server. Must be set 

when using the e-mail function

PJ name

*

3

 ......... Sets name of the projector. (64 characters maxi-

mum)

✐

  You  must  use  the  number  specified  by  your  administrator. 

The address must be entered as a group with four numbers 

split by a dot like [192.168.001.101].