Panasonic WV-CU650 ユーザーズマニュアル
23
● Group Address Setting for System
Controller
Note: Remain the factory default. When you have mistaken-
ly changed the setting, recover the factory default as
follows.
follows.
1. Select “Cnt G-Adr.” by rotating the JogDial.
(Refer to Step 5 in p. 21.)
2. Press the CAM (SET) button.
The LCD display will change from the display mode to
the editing mode.
the editing mode.
3. Select a desired parameter by rotating the JogDial
or pressing the + or – button.
You can select the desired parameter from “A” to “Z”.
The factory default is “A”.
You can select the desired parameter from “A” to “Z”.
The factory default is “A”.
4. Press the MON (ESC) button.
The selected parameter will be determined, and the
LCD display will return to the display mode.
LCD display will return to the display mode.
● Group Address Setting for System
Units
Note: Remain the factory default. When you have mistaken-
ly changed the setting, recover the factory default as
follows.
follows.
1. Select “Sys G-Adr.” by rotating the JogDial.
(Refer to Step 5 in p. 21.)
2. Press the CAM (SET) button.
The LCD display will change from the display mode to
the editing mode.
the editing mode.
3. Select "A" by rotating the JogDial or pressing the +
or – button.
4. Press the CAM (SET) button.
The parameter will be determined, and the cursor will
jump to the sub parameter.
jump to the sub parameter.
5. Enter the unit number of system unit by rotating the
JogDial or pressing the + or – button.
Note: 1 to 99 is available for the unit number. The facto-
ry default is 01.
6. Press the CAM (SET) button.
The sub parameter will be determined, and "OK" will
appear on the LCD.
appear on the LCD.
After a second, the LCD display will return to the status
in Step 5.
If you set the unit numbers of other system units, repeat
Step 5.
in Step 5.
If you set the unit numbers of other system units, repeat
Step 5.
Note: If the parameters cannot be determined, "NG" will
appear on the LCD. In this case, check the unit
number of system unit, and repeat Step 3 to 6.
number of system unit, and repeat Step 3 to 6.
7. Press the MON (ESC) button.
The LCD display will return to the status in Step 2.
8. Press the MON (ESC) button again.
The LCD display will return from the editing mode to the
display mode.
display mode.
•
PS Data Com. Setup
Cnt G—Adr.B
•
PS Data Com. Setup
Cnt G—Adr.A
•
PS Data Com. Setup
Cnt G—Adr.A
•
PS Data Com. Setup
Sys G—Adr.B
•
PS Data Com. Setup
Sys G—Adr.A
•
PS Data Com. Setup
Sys G—Adr.A 05
•
PS Data Com. Setup
Sys G—Adr.A 01
•
PS Data Com. Setup
Sys G—Adr.A 01 OK