Verizon 7500 ユーザーズマニュアル

 

 

 

 
 

030-300536 Rev. A 

160 

     August 2007 

 

 
In the Advanced screen, click Private LAN. The following screen will appear. Private LAN allows you to set up a 
network behind your Router. 
 
If you change the settings in this screen, click Apply. If you click Reset, the screen will refresh and the previously 
saved settings will remain active. 
 
IMPORTANT: Whenever you change the settings in a screen, the screen will display the changes; however, you must 
click Apply to allow the changes to take effect in the Router. (Private LAN is the default setting for VersaLink.) 
 

 

 

Private LAN DHCP Server Enable 

Default = Enabled 
If this box contains a check mark, this enables DHCP addresses to be 
served from the Private LAN pool. 

Private LAN Enable 

Default = Enabled 
If this box contains a check mark, this enables the addresses from the 
Private LAN to use the NAT interface. 

Modem IP Address 

Displays the Router’s IP address. 

Subnet Mask 

Displays the Subnet Mask, which determines what portion of an IP 
address is controlled by the network and which portion is controlled by the 
host. 

DHCP Start Address 

Displays the first IP address that the DHCP server will provide. 

DHCP End Address 

Displays the last IP address that the DHCP server will provide. 

DHCP Lease Time 

Displays the amount of time the provided addresses will be valid, after 
which the DHCP client will usually resubmit a request. 

Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be 
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.