Omron C200H-LK401 ユーザーズマニュアル

Observe the following when soldering wires onto the connector.

1.

Place heat-shrinking tubes onto all wires far enough from the end so as
to not interfere with soldering.

2.

Presolder all wires and connector terminals.

3.

Solder all wires, inserting 4 mm of the exposed 5 mm of wire into the
connector terminal.

4.

Move the heat-shrinking tubes onto the soldered area and shrink them
into place.

Assemble the connector hood as shown the following diagram. See the con-
nection diagrams above to confirm whether one end is or is not to be con-
nected to the shield wire.

ÇÇ

ÇÇ

Aluminum foil tape

Hood (FG) connected
to shield wire

Hood (FG) not connected
to shield wire

Unit: mm

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

ÉÉ

250

100*

Approx.
150**

Backplane

35