Nortel Networks NN44200-300 ユーザーズマニュアル
54
Chapter 5 Installing the server and connecting the peripheral devices
Note: For details on the DC power source for 1002rp DC servers, see
To connect the 1002rp AC server to power
Step
Action
WARNING
The power outlets used by the CallPilot server and its peripheral
devices must be connected to the same single-point ground
reference as the one used by the switch with MGate cards
(NTRB18CA) connected to the CallPilot server. If this requirement
is not met, power transients can cause personal injury, or hardware
failure, or both. Refer to the Installation and Configuration Task
List (NN44200-306) for more information on single-point grounding
requirements.
devices must be connected to the same single-point ground
reference as the one used by the switch with MGate cards
(NTRB18CA) connected to the CallPilot server. If this requirement
is not met, power transients can cause personal injury, or hardware
failure, or both. Refer to the Installation and Configuration Task
List (NN44200-306) for more information on single-point grounding
requirements.
1
Plug the server AC power cord into the server rear panel.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.