Nortel Networks NN44200-313 ユーザーズマニュアル
Backing up the system
53
8
In the Channel Monitor page, under Channel Status, check that
two channels are shown in dark blue indicating an idle status.
two channels are shown in dark blue indicating an idle status.
Tech tip: If a channel status is red, check the DS30 cabling and then
check the telephony switch provisioning. A cable may be plugged
into the wrong slot or a card may be disabled or not provisioned.
check the telephony switch provisioning. A cable may be plugged
into the wrong slot or a card may be disabled or not provisioned.
—End—
Backing up the system
Note: At this point, a backup is recommended but not necessary. It
serves as a point to restore from if something should happen during
testing. It also serves as a way to test the tape drive to ensure it is in
working order. This procedure takes approximately 20 min.
serves as a point to restore from if something should happen during
testing. It also serves as a way to test the tape drive to ensure it is in
working order. This procedure takes approximately 20 min.
The following procedure describes how to perform a backup to a tape drive.
Note: For information about the advanced method of backing up to a
network device, refer to the Software Administration and Maintenance
NTP (NN44200-600) or the CallPilot Manager online Help.
network device, refer to the Software Administration and Maintenance
NTP (NN44200-600) or the CallPilot Manager online Help.
Step
Action
1
If the tape drive is not already turned on, turn it on, and then ensure
that an SLR 75 tape is inserted.
that an SLR 75 tape is inserted.
2
In the CallPilot Manager toolbar, select System > Backup/Restore.
3
In the Backup/Restore page, do the following:
a. From the Select a task list, select Review and schedule
backups.
b. Click Add Backup.
4
In the Add New Backup Schedule page, do the following:
a. From the Select a backup type list, select Full System Backup.
b. From the Select a backup device list, select PrimaryServer-
Tape.
c. From Additional Options, select Backup will overwrite any
existing data on tape.
d. Click Next.
5
In the Add New Backup Schedule page, do the following:
a. From the Select the backup frequency list, select One time
only.
Nortel CallPilot
Quickstart Guide
NN44200-313
01.02
Standard
5.0
19 May 2008
Copyright © 2007-2008, Nortel Networks
.