Nortel Networks R2MFC ユーザーズマニュアル

Chapter 2 Overview 23

R2MFC Media Bay Module Installation and Configuration Guide

The R2MFC MBM has three visual status monitor indicators on the left side of the faceplate. They 
are:

•

Power LED — This green LED indicates the status of power to the R2MFC MBM.

•

In Service LED — This green LED indicates the status of the E1 signal coming to the 
R2MFC MBM from the BCM.

•

Diag LED — This red LED indicates if the R2MFC MBM is in a diagnostic or loopback 
mode.

The R2MFC MBM has six config DIP switches on its faceplate. These DIP switches are used to 
set the following configurations for the R2MFC MBM:

•

country

•

problem diagnosis

•

second dial tone

DIP switches must be set before power is connected to the R2MFC MBM. 

 shows the 

Config DIP switches.

Figure 3   Config DIP Switches

For DIP switch values and configuration information, see 

.

These DIP switches are also used for problem diagnostics. For specific settings and uses, see

1

2

3

4

5

6

O

N