Nortel Networks 201i ユーザーズマニュアル

November 2006

About the 201i server

201i Server Hardware Installation

29

The following table identifies the purpose of each connector on the 
NTRH0912

1

 multi I/O cable.

Note: Labels on the RJ-45 cables distinguish the CLAN and ELAN 
connectors.

1.For customers in EUED countries: see Appendix A, “RoHS part conversion table,” to look up part 
numbers for RoHS-compliant parts that are equivalent to the non-RoHS-compliant parts described in 
this guide.

50-pin amphenol

This connector establishes the connection between 
the Meridian 1 or Succession 1000 Media Gateway 
or Media Gateway Expansion backplane and the 
ELAN hub, the CLAN hub, and the modem.

10Base-T 
(RJ-45)

This connector provides a 10 Mbit/s Ethernet 
connection between the 201i server and the 
Meridian 1 switch or Succession 1000 system. This 
connection allows the exchange of call control 
information between the server and the Meridian 1 
switch or Succession 1000 system.

For more information about the ELAN, see “About 
the ELAN” in the CallPilot Installation and 
Configuration Task List.

10/100Base-T 
(RJ-45)

This connector provides a network connection for

„

user desktop computers, to enable use of the 
unified messaging and fax messaging features

„

LAN-based server administration

If you need Ethernet 100Base-T operation at 
100 Mbit/s on large Meridian 1 systems (such as 
Option 51), you must install the NTRH3501 
backplane (tip and ring) cable. For more information, 
see Chapter 4, “Installing the 201i server in a large 
Meridian 1 system.”