Nortel Networks 4050 ユーザーズマニュアル
Chapter 4 Configuring the domain 127
Nortel Secure Network Access Switch 4050 User Guide
11 To add a network access device, enter the required information when
prompted. For more information, see
To continue, go to
.
12 Specify the action to be performed when an SRS rule check fails. The options
are:
•
restricted
— the session remains intact, but access is restricted in
accordance with the rights specified in the access rules for the group
•
teardown
— the SSL session is torn down
The default is
restricted
.
13 Specify whether you want to create a test user (
tg
) in the default
tunnelguard
group.
If you do want to create a test user, press Enter to accept the default value
(
(
yes
). The wizard will create a test user named
tg
, with password
tg
, in the
default
tunnelguard
group.
If you do not want to create a test user, enter
no
.
14 Wait while the wizard completes processing to create the domain, then enter
Apply
to activate the changes.
Do you want to configure a switch? (yes/no) [no]: yes
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]:
IP address of Switch:
NSNA communication port[5000]:
Red vlan id of Switch:
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]:
IP address of Switch:
NSNA communication port[5000]:
Red vlan id of Switch:
In the event that the TunnelGuard checks fails on a
client, the session can be teardown, or left in
restricted mode with limited access.
Which action do you want to use for TunnelGuard failure?
(teardown/restricted) [restricted]:
client, the session can be teardown, or left in
restricted mode with limited access.
Which action do you want to use for TunnelGuard failure?
(teardown/restricted) [restricted]:
Do you want to create a tunnelguard test user? (yes/no)
[yes]:
[yes]: