Nxp Semiconductors UM10237 ユーザーズマニュアル

UM10237_2

© NXP B.V. 2008. All rights reserved.

Internally, there is a hardware FIFO status flag called Buffer_Full. This flag is set by the 
Validate Buffer command and cleared when the data has been sent on the USB bus and 
the buffer is empty.

A control IN buffer cannot be validated when its corresponding OUT buffer has the Packet 
Over-written (PO) bit (see the Clear Buffer Register) set or contains a pending SETUP 
packet. For the control endpoint the validated buffer will be invalidated when a SETUP 
packet is received.

 for a description of when this command is 

used.

The LPC2400 USB device controller initialization includes the following steps:

1. Enable the device controller by setting the PCUSB bit of PCONP.

2. Configure and enable the PLL and Clock Dividers to provide 48 MHz for usbclk, and 

the desired frequency for cclk. For correct operation of synchronization logic in the 
device controller, the minimum cclk frequency is 18 MHz. For the procedure for 
determining the PLL setting and configuration, see 

.

3. Enable the device controller clocks by setting DEV_CLK_EN and AHB_CLK_EN bits 

in the USBClkCtrl register.  Poll the respective clock bits in the USBClkSt register until 
they are set.

4. Select the desired USB port pins using the USBPortSel register.  The 

PORTSEL_CLK_EN bit must be set in USBClkCtrl before accessing USBPortSel and 
should be cleared after accessing USBPortSel.

5. Enable the USB pin functions by writing to the corresponding PINSEL register.

6. Disable the pull-up resistor on the V

BUS

 pin using the corresponding PINMODE 

register.

7. Set USBEpIn and USBMaxPSize registers for EP0 and EP1, and wait until the 

EP_RLZED bit in USBDevIntSt is set so that EP0 and EP1 are realized.

8. Enable endpoint interrupts (Slave mode):

– Clear all endpoint interrupts using USBEpIntClr.

– Clear any device interrupts using USBDevIntClr.

– Enable Slave mode for the desired endpoints by setting the corresponding bits in 

USBEpIntEn.

– Set the priority of each enabled interrupt using USBEpIntPri.

– Configure the desired interrupt mode using the SIE Set Mode command.

– Enable device interrupts using USBDevIntEn (normally DEV_STAT, EP_SLOW, 

and possibly EP_FAST).

9. Configure the DMA (DMA mode):

– Disable DMA operation for all endpoints using USBEpDMADis.

– Clear any pending DMA requests using USBDMARClr.