Lucent Technologies Network Access Module ユーザーズマニュアル
Installation and Configuration Steps
1-4
INA Module Installation and Configuration Guide
Ethernet Port. This RJ-45 connector provides a 10BaseT Ethernet connection. See
“Connect an Ethernet Cable” on page 3-4.
“Connect an Ethernet Cable” on page 3-4.
Ethernet Link LED. This green LED indicates link integrity to a 10BaseT hub. See
“Ethernet LEDs” on page 3-6.
“Ethernet LEDs” on page 3-6.
Reboot Button. This button resets the router hardware and reboots ComOS. It has no
effect on MERLIN MAGIX voice operation. You will need a thin object such as a
straightened paper click to activate this recessed switch.
effect on MERLIN MAGIX voice operation. You will need a thin object such as a
straightened paper click to activate this recessed switch.
T1/PRI Connection. This RJ-45 connector connects the T1/PRI line. See “Connect a
T1/PRI Cable” on page 3-3.
T1/PRI Cable” on page 3-3.
DS-1 Test Jacks. There are three pairs of jacks for DS-1 troubleshooting. See “Using
the DS-1 Test Jacks” on page A-5.
the DS-1 Test Jacks” on page A-5.
Installation and Configuration Steps
1.
Collect information about your T1 or PRI line.
See “T1/PRI Provisioning” on page 2-1 for a preview of the values you need.
2.
Collect information about the network and routing configuration.
See “Network Settings” on page 2-2 for a preview of the values you need.
3.
Install the INA module in the MERLIN MAGIX system.
4.
Configure the T1 or PRI line using the MERLIN MAGIX console.
5.
Assign data channels to the router using the MERLIN MAGIX console.
6.
Connect the INA module front panel cables.
7.
Configure the INA module.
See one of the following:
–
–
–